The Effect of Internal Lubricants on the Accuracy of Injection Molded Thermoplastic Gears

Paper #:
  • 1999-01-0851

Published:
  • 1999-03-01
Citation:
Williams, E. and Kleiss, R., "The Effect of Internal Lubricants on the Accuracy of Injection Molded Thermoplastic Gears," SAE Technical Paper 1999-01-0851, 1999, https://doi.org/10.4271/1999-01-0851.
Pages:
9
Abstract:
This paper will examine the effect that PTFE, silicone and other internal lubricants have on the mold shrink rate of thermoplastic gear materials and the resulting effect on the accuracy of the molded gear. “Standard” thermoplastic mold shrinkage data is generated on relatively large test samples which do not represent the flow, orientation and heat transfer seen in a typical molded gear. Additionally, different parts of the gear can be expected to shrink at different rates, leading to potential errors if a single “generic” mold shrink rate is used to design and machine the gear mold cavity. Using a single cavity gear mold, the shrink rate of different internally lubricated gear materials is measured and compared to the unlubricated base resin. The shrink rate of individual parts of the gear are compared, as well as the resultant total composite variation. A discussion on the techniques used to measure the gears, as well as the expected consequences of the resultant shrinkage on the gear train, will be included. This data can be used to increase the accuracy of molded thermoplastic gears.
Access
Now
SAE MOBILUS Subscriber? You may already have access.
Buy
Select
Price
List
Download
$27.00
Mail
$27.00
Members save up to 40% off list price.
Share
HTML for Linking to Page
Page URL

Related Items

Technical Paper / Journal Article
2010-10-25
Article
2017-03-13
Technical Paper / Journal Article
2010-10-25
Training / Education
2018-05-03