A Study of the Influence of Nozzle Orifice Geometries on Fuel Evaporation using Laser-Induced Exciplex Fluorescence 2003-01-1836
Projected stringent emissions legislation will make tough demands on engine development. For diesel engines, in which combustion and emissions formation are governed by the spray formation and mixing processes, fuel injection plays a major role in the future development of cleaner engines. It is therefore important to study the fundamental features of the fuel injection process.
In an engine the fuel is injected at high pressure into a pressurized and hot environment of air, which causes droplet formation and fuel evaporation. The injected fuel then forms a gaseous phase surrounding the liquid phase. The amount of evaporated fuel in relation to the total amount of injected fuel is of importance for engine performance, i.e. ignition delay and mixing rate.
In this paper, the fraction of evaporated fuel was determined for sprays, using different orifice diameters ranging from 0.100 mm up to 0.227 mm, with the aid of a high-pressure spray chamber. The conicity of the orifice was also varied. Three injection pressures and two chamber temperatures were also used. The amount of evaporated fuel was determined by laser-induced exciplex fluorescence measurement of the gaseous and liquid phases of the fuel spray. The measurement of the phases consists of time-resolved, two-dimensional images. The fuel in this study consisted of a mixture of 1-cyanonaphthalene, N,N-dibutylaniline and n-dodecane. The fuel was excited by a laser wavelength of 355 nm. The results show a strong reduction of fuel penetration for one of the conical orifices. It was also found that both increased injection pressure and reduced orifice diameter reduce the liquid volume fraction of the spray, i.e. the gas volume fraction increases.
Citation: Bergstrand, P., Persson, F., Försth, M., and Denbratt, I., "A Study of the Influence of Nozzle Orifice Geometries on Fuel Evaporation using Laser-Induced Exciplex Fluorescence," SAE Technical Paper 2003-01-1836, 2003, https://doi.org/10.4271/2003-01-1836. Download Citation
Author(s):
Pär Bergstrand, Fredrik Persson, Michael Försth, Ingemar Denbratt
Affiliated:
Volvo Powertrain Corporation, Chalmers University of Technology and Göteborg University
Pages: 14
Event:
2003 JSAE/SAE International Spring Fuels and Lubricants Meeting
ISSN:
0148-7191
e-ISSN:
2688-3627
Also in:
Premixed Charge Ci Engines & Diesel Spray & Mixture Formation-SP-1794, SAE 2003 Transactions Journal of Fuels and Lubricants-V112-4
Related Topics:
Fuel injection
Diesel / compression ignition engines
Combustion and combustion processes
Emissions
Pressure
Lasers
SAE MOBILUS
Subscribers can view annotate, and download all of SAE's content.
Learn More »