Spring Back of Radial Shaft Seals with Rubber OD 920717
The phenomenon of the spring back of radial shaft seals with rubber covered OD, looking for the first glance as a marginal one, should not be ignored during the seal design. From the numerical analysis of the installation process supplemented with experimental data results a considerable influence of the front part of the rubber layer covering the seal case on the run of tangential force and spring back. It will be shown that it is possible by proper design of the rubber layer on OD to counteract the spring back of the seal.
Citation: Gawlinski, M., Konderla, P., and Upper, G., "Spring Back of Radial Shaft Seals with Rubber OD," SAE Technical Paper 920717, 1992, https://doi.org/10.4271/920717. Download Citation
Author(s):
Marek Gawlinski, Piotr Konderla, Gerd Upper
Affiliated:
Technical University of Wroclaw
Pages: 15
Event:
International Congress & Exposition
ISSN:
0148-7191
e-ISSN:
2688-3627
Also in:
Automotive Sealing-SP-0921, SAE 1992 Transactions: Journal of Engines-V101-3
Related Topics:
Seals and gaskets
Elastomers
Springs
SAE MOBILUS
Subscribers can view annotate, and download all of SAE's content.
Learn More »
