Modelling of Atomization Process in Flash Boiling Spray

Paper #:
  • 941925

Published:
  • 1994-10-01
Citation:
Senda, J., Hojyo, Y., and Fujimoto, H., "Modelling of Atomization Process in Flash Boiling Spray," SAE Technical Paper 941925, 1994, https://doi.org/10.4271/941925.
Pages:
17
Abstract:
This paper presents the analysis of atomization and vaporization processes in a flash boiling spray based on experimental results obtained from injection systems in the suction manifold of a gasoline engine. Two kinds of liquid fuel, n-Pentane and n-Hexane, were injected into quiescent atmosphere at room-temperature and low-pressure through a pintle type injector with electronic control. The spray characteristics of both fuels below various atmospheric pressures were investigated in detail by taking photography. Then, in the region of flash boiling, where the back pressure was below the saturated vapor pressure of fuel, the bubble nucleation process due to the flash boiling was modelled by both the measurement results of bubble and the nucleation rate equation using the degree of superheat of the liquid fuel. Further, the fuel vaporization process was assessed by the bubble growth calculation in vapor cavitation phenomena, the fuel evaporation due to boiling from the liquid film surface and the evaporation process from the film surface owing to heat transfer between the ambient gas and the liquid film. Accordingly, the transient change in the bubble diameter and the vapor mass fraction inside the spray are estimated quantitatively for each back pressure. The calculated results, such as the shape of fuel film jet and the fuel droplet diameter in the spray, agree well with the experimental results.
Access
Now
SAE MOBILUS Subscriber? You may already have access.
Buy
Select
Price
List
Download
$27.00
Mail
$27.00
Members save up to 40% off list price.
Share
HTML for Linking to Page
Page URL

Related Items

Training / Education
2018-07-16
Training / Education
2018-06-05
Training / Education
2018-03-26