Mathematical analysis

Viewing 1 to 50 of 2577

2011-01-2594

Application of Genetic Algorithm for Preliminary Trajectory Optimization

Pervier, H., Nalianda, D., Espi, R., Sethi, V. et al.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-2594

2011-01-2616

Innovative Algorithm for Spacecraft Attitude Determination

Caporaletti, G.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-2616

2011-28-0112

Calculation Method for Steer Angle by Two Angle Sensor

Jooil, P.
SAE Technical Paper, 2011 , doi:10.4271/2011-28-0112

2011-01-1941

Regression Equations for Predicting the Cetane Number of Biodiesel Fuel Based on Fuel Composition and Properties

Kawasaki, K., Yamane, K., and Ikawa, T.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1941

2011-38-0022

Robust Moving Meshes for the Prediction of Aerodynamic Degradation during In-Flight Icing

Fossati, M., Khurram, R., and Habashi, W.
SAE Technical Paper, 2011 , doi:10.4271/2011-38-0022

2011-38-0004

Improvements in Numerical Analysis of Droplet Impingement Using Lagrangian Approach

Ke, P. and Wang, X.
SAE Technical Paper, 2011 , doi:10.4271/2011-38-0004

2011-38-0005

Lagrangian Parcel Volume Method for Unsteady Particle Concentration

Mickey, J., Loth, E., and Bidwell, C.
SAE Technical Paper, 2011 , doi:10.4271/2011-38-0005

2011-01-1660

Engine Fault Detection Using Vibration Signal Reconstruction in the Crank-Angle Domain

Arasaratnam, I., Habibi, S., Kelly, C., Fountaine, T. et al.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1660

2011-39-7201

Development of a High-Fidelity Series-Hybrid Electric Vehicle Model using a Mathematics-Based Approach

Dao, T., Seaman, A., McPhee, J., and Shigematsu, K.
SAE Technical Paper, 2011

2011-01-0025

Virtual Road Load Data Acquisition in Practice at General Motors

Schudt, J., Kodali, R., Shah, M., and Babiak, G.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0025

2011-01-0228

Bearing Surface Requirements (Waviness) for Driveline Shafts

Konstantino, A. and Levine, M.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0228

2011-01-0486

Stress Concentration Factor Solutions for Shoulder Filleted Shafts in Bending, including the Influence of Tapering

Tipton, S., Schmidt, C., and Sorem, J.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0486

2011-01-0447

Metrics for Quantifying and Evaluating Ability of Electronic Control System Architectures to Accommodate Changes

Ghosal, A., Giusto, P., Peranandam, P., Sinha, P. et al.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0447

2011-01-0411

Numerical and Experimental Investigation of Airflow through Check Valve of Vacuum Pump for Automotive Application

Pandarinath, H., Sureshkumar, J., Sivanantham, R., Prabhakar, S. et al.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0411

2011-01-0747

System of the Automatic Preventive On-Line Monitoring and Diagnostics of Car Engines on the Basis of the New Methods of Preventive Diagnostics

Kirillov, S., Kirillov Sr, A., and Kirillova, O.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0747

2011-01-0695

L3 and V6 Engine Applications

Javaherian, H., Brown, A., and Nolan, M.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0695

2011-01-0785

Equilibrium Mechanism Based Linear Curve Fitting Method and Its Application

Wei, Z., Yang, F., and Cheng, H.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0785

2011-01-1080

Multi-Objective Decision Making under Uncertainty and Incomplete Knowledge of Designer Preferences

Pandey, V., Nikolaidis, E., and Mourelatos, Z.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1080

2011-01-1077

Shape Optimization of a Single Cylinder Engine Crankshaft

Cevik, M., Kanpolat, E., and Rebbert, M.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1077

2011-01-1345

Methodology for Calculating Cost-per-Mile for Current and Future Vehicle Powertrain Technologies, with Projections to 2024

Timbario, T., Timbario, T., Laffen, M., and Ruth, M.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1345

2011-01-1079

New Proposal of Piston Skirt Form using Multi Objective Optimization Method

Kobayashi, T.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-1079

2011-01-0127

A Simple Method to Calculate Vehicle Heat Load

Zheng, Y., Mark, B., and Youmans, H.
SAE Technical Paper, 2011 , doi:10.4271/2011-01-0127

2011-26-0103

Process Improvements in Structural Optimization and NVH

Fischer, R., Klein, M., and Wulf, C.
SAE Technical Paper, 2011 , doi:10.4271/2011-26-0103

2009-01-3210

Numerical Analysis of Static Behavior in a Three-point Bending Test of Aluminum Foam Sandwich Beams using the Extended Finite Element Method

Hahn, Y. and Cheon, S.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-3210

2009-01-3166

Design and Experimental Investigation of a Small UAV

Coffin, P., Ahmadi, G., Jha, R., Marzocca, P. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-3166

2009-01-2621

A Thermodynamic Evaluation of the Use of Alcohol Fuels in a Spark-Ignition Engine

Caton, J.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2621

2009-01-2620

Effects of Engine Settings and Gas Quality

Khalil, S., Camal, R., Olivier, L., and Laurent, T.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2620

2009-01-2639

Applications of Tuning Fork Resonators for Engine Oil, Fuel, Biodiesel Fuel and Urea Quality Monitoring

Milpied, J., Uhrich, M., Patissier, B., and Bernasconi, L.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2639

2009-01-2660

Impact of Biodiesel on Lubricant Corrosion Performance

Richard, K. and McTavish, S.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2660

2009-01-2659

Development of a Quasi-Dimensional Combustion Model for Stratified SI-Engines

Schmid, A., Grill, M., Berner, H., Bargende, M. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2659

2009-01-2684

Application of Neural Networks for Prediction and Optimization of Emissions and Performance in a Hydrogen Fuelled Direct Injection Engine Equipped With In Cylinder Water Injection

Gadallah, A., Elshenawy, E., Elzahaby, A., El-Salmawy, H. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2684

2009-01-2672

Nano Particulate Matter Evolution in a CFR1065 Dilution Tunnel

Wu, Y., Clark, N., Carder, D., and Shade, B.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2672

2009-01-2671

Characteristics of Soot Deposits in EGR Coolers

Teng, H. and Regner, G.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2671

2009-01-2673

Speciated Engine-Out Organic Gas Emissions from a PFI-SI Engine Operating on Ethanol/Gasoline Mixtures

Kar, K. and Cheng, W.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2673

2009-01-2717

Design and Control Considerations for a Series Heavy Duty Hybrid Hydraulic Vehicle

Surampudi, B., Nedungadi, A., Ostrowski, G., Montemayor, A. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2717

2009-01-2749

Air-to-Fuel and Dual-Fuel Ratio Control of an Internal Combustion Engine

Pace, S. and Zhu, G.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2749

2009-01-2821

Multi-scale Theoretical Study of Sintering Dynamics of Pt for Automotive Catalyst

Suzuki, A., Sato, R., Nakamura, K., Okushi, K. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2821

2009-01-2494

Theoretical Analysis for Long-Term Space Life Support Reliability

Holubnyak, Y. and Rygalov, V.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-2494

2009-01-1767

Exploratory Work for the Definition of the Test Protocol

Giechaskiel, B., Carriero, M., Martini, G., and Andersson, J.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1767

2009-01-1796

Prediction of Combustion Delay and -Duration of Homogeneous Charge Gasoline Engines based on In-Cylinder Flow Simulation

Wiese, W., Pischinger, S., Adomeit, P., and Ewald, J.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1796

2009-01-1804

Investigations on the Heat Transfer in HCCI Gasoline Engines

Hensel, S., Sarikoc, F., Schumann, F., Kubach, H. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1804

2009-01-1820

Numerical Analysis of the Dynamic Behaviour of Axial Piston Pumps and Motors Slipper Bearings

Borghi, M., Specchia, E., and Zardin, B.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1820

2009-01-1838

Development of a Hybrid Electric Mid-Sized Bus for Urban Transport

Kural, E., Ararat, O., Sezer, V., Solak, Y. et al.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1838

2009-01-1840

Diesel EGR Cooler Fouling at Freeway Cruise

Mulenga, M., Chang, D., Tjong, J., and Styles, D.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1840

2009-01-1863

Different Simulation Models of Connecting Rod Hydrodynamic Bearing

Tabrizi, A. and Kakaei, A.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1863

2009-01-1859

Zero-dimensional Model and Pressure Data Analysis of a Variable-Displacement Lubricating Vane Pump

Barbarelli, S., Bova, S., and Piccione, R.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1859

2009-01-1867

Energy Conversion Efficiency of Hybrid Electric Heavy-duty Vehicles

Katrašnik, T.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1867

2009-01-1868

Online Implementation of an Optimal Supervisory Control for a Parallel Hybrid Powertrain

Chasse, A., Pognant-Gros, P., and Sciarretta, A.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1868

2009-01-1881

Development of a Direct Injection High Efficiency Liquid Phase LPG Spark Ignition Engine

Boretti, A. and Watson, H.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1881

2009-01-1880

Development of a Fuel Spray Impulse Measurement Device and Correlation with Time Resolved Mass Flow

Lindström, M. and Ångström, H.
SAE Technical Paper, 2009 , doi:10.4271/2009-01-1880

Viewing 1 to 50 of 2577

Mathematical analysis

Products

Resources

General Information