Ethanol Autoignition Characteristics and HCCI Performance for Wide Ranges of Engine Speed, Load and Boost

Magnus Sjoberg; John E. Dec

doi:10.4271/2010-01-0338

The characteristics of ethanol autoignition and the associated HCCI performance are examined in this work. The experiments were conducted over wide ranges of engine speed, load and intake boost pressure (P_iⁿ) in a single-cylinder HCCI research engine (0.98 liters) with a CR = 14 piston.

The data show that pure ethanol is a true single-stage ignition fuel. It does not exhibit low-temperature heat release (LTHR), not even for boosted operation. This makes ethanol uniquely different from conventional distillate fuels and offers several benefits: a) The intake temperature (T_iⁿ) does not have to be adjusted much with changes of engine speed, load and intake boost pressure. b) High P_iⁿ can be tolerated without running out of control authority because of an excessively low T_iⁿ requirement.

However, by maintaining true single-stage ignition characteristics, ethanol also shows a relatively low temperature-rise rate just prior to its hot ignition point. Therefore, ethanol does not tolerate as much combustion-phasing retard as fuels that exhibit LTHR and/or pronounced intermediate-temperature heat release. Since combustion retard is important for avoiding excessive pressure-rise rates, the distinct single-stage ignition characteristic of ethanol can be considered a drawback when reaching for higher loads. Nonetheless, an IMEP_g of 11.3 bar was demonstrated for P_iⁿ = 247 kPa.

Finally, the latest ethanol chemical-kinetics mechanism from the National University of Ireland - Galway was evaluated against the experimental engine data using a multi-zone model. Overall, the mechanism performs very well over wide ranges of operating conditions.

Standards

SAE Mobilus®

Publications

News

Events

Professional Development

A World in Motion (PreK-12)

Participate with SAE

SAE Membership

Donate

Ethanol Autoignition Characteristics and HCCI Performance for Wide Ranges of Engine Speed, Load and Boost 2010-01-0338

SAE MOBILUS